Beiträge von Milton1

  • Exige S3 "1980 JPS Gold" gloss felgen + 6 Reifen

    Guten Tag,

    I am so sorry to write in English (I can read German but it is difficult to write it for me).

    I am selling my extra set of wheels "1980 JPS Gold" gloss (Mars Gold) + reifen Pirelli P Zero Corsa with front +- 5.5mm and rear +- 4.5mm tread left.

    + colour coded balancing weights

    + black/gold center caps

    + 2 extra Pirelli P Zero Corsa LS 205/45/17 with +- 6.5mm left.

    The wheels are 100% perfect, as they have only been on the car for Lotus meetings or car shows.

    Pictures are taken one hour ago... I put the wheels on the car because being bored by corona :(

    Ideally, pickup in Belgium - Keerbergen

    950 EUR for all.

    Viel Mut in diesen schwierigen Zeiten :)

    Danke

    Kristof

  • Exige / Elise / Exige V6: neue Transforged Seitenspiegels

    Hi Norbert,

    thanks for your question. The mirrors are mounted with the included (but not on the picture) screws that go through the bottom two existing mounting holes where the OEM mirrors are mounted. I have no pictures from them on my car as I didn't install them, so all pictures are from the internet.

    I specifically bought these mirrors as my OEM mirrors used to fold closed at speeds > 200 kmh. But, I fixed that (degreased the springs with brake cleaner). I was plannig on installing these carbon mirrors together with the Reverie carbon side intakes. However, Reverie doesn't make these anymore...? So I decided to keep the OEM Military Grey ones on my car.

    The mirrors have a very strong stem (they are racing bike mirrors as far as I know).

    I have a bad-quality close up picture that doesn't show much I'm afraid:


    Another picture from internet, but this is with the gloss mirror mount. Mine are MATT black, same colour as the window frame:

  • Exige / Elise / Exige V6: neue Transforged Seitenspiegels

    Hello everybody, sorry I write this in English... I can read German but I can't write it.

    I'm selling my new, never installed, Transforged USA side mirrors. The mirrors themselves are in real carbon, the mirror mount is matt black.

    Can be installed with OEM mounting holes on all Elise and Exige (including V6). On the V6 there is a third mounting hole that becomes visible. Therefore, 2x matt black vinyl is included for the mirror plinth.

    I have bought these last summer and including taxes and custom duties payed 560 EUR. I'm selling these, brand new, for 460 EUR including shipping to Belgium neighbour countries.


    Some pictures courtesy of Mick (Transforged) and Ryan Cruz:



    All the best,
    Grussen aus Belgien :)
    Kristof

  • Rückfahrkamera

    Zitat von Blue1000

    Thanks for the info. The wifi solution is a bit complicated and time consuming if you need a rear-view immediately.

    I'm interested in the wiring of your cam. I plan to connect it to the reverse light in the trunk. But i'm not sure how to do it and if there's any opening to the trunk for this wire.

    It takes about 5 seconds for the transmitter to start the connection. Therefore I have wired it to the rear window heater feedback light. I tapped into this power line in the rear fuse box. If you would wire it to the reverse lights, you would need to put it in reverse, wait 5 seconds. But even worse is that when you go out of reverse and then back again (like parking), you will need to wait again 5 seconds. Connected to the rear window heater feedback light, you can start the car, push the button for the rear defroster and in 5 seconds you have the image. You can even leave it on (up to 10 mins) when you drive away.

    I have "Tasker" installed on the phone so as soon as it sees the camera wifi connection, it launches the app.

    The switch over is immediate.

    I used this fuse holder. It plugs in directly in the rear fuse box.

    To connect the camera to the transmitter, I have drilled 2 3mm holes for the cables and used a rubber grommet to isolate the cables.

    Alternatively you can connect the camera to a display in the car. You can route the cable then via the shifter cables. I used this route for my lambda sensor for the afr gauge.

  • Rückfahrkamera

    Zitat von jbs

    Das sieht ja sehr dezent und geschickt gelöst aus, aber gibt's dabei kein Risiko auf Überhitzung ?

    Sorry I write in English... this is in fact my car.

    Camera is cheap Conrad camera. The transmitter is a WLAN version. The transmitter & camera are powered from the rear window heater. The rear heater turns off automatically after 10 minutes, so the transmitter doesn't keep transmitting if I would forget to turn it off.

    Works very well. No problem with heat.

    The video is displayed on a 5.5" android phone.


    Grussen aus Belgien :D

  • Exige V6: Lotus Motorsport Cup R Cold Air Intake

    Hello,

    sorry for me writing in English: I'm from Belgium and I can read German, but I can't write it :D

    I'm offering for sale my Lotus Motorsport Cup R Cold Air intake for Lotus Exige V6:


    As installed on the Cup R - 366 bhp (without cat):


    A small movie to enjoy the supercharger sound:

    Externer Inhalt www.youtube.com
    Inhalte von externen Seiten werden ohne Ihre Zustimmung nicht automatisch geladen und angezeigt.
    Durch die Aktivierung der externen Inhalte erklären Sie sich damit einverstanden, dass personenbezogene Daten an Drittplattformen übermittelt werden. Mehr Informationen dazu haben wir in unserer Datenschutzerklärung zur Verfügung gestellt.


    6 months old - 2000 kms - like new. Reason for change: Komotec EX430 installation with Komotec CAI

    At Lotus Motorsport: 952€ + MwSt

    FOR SALE: 400 € + transport (versand +/- 20 €).

    PM or audiotec@telenet.be

    Vielen Grussen,

    Kristof