Lotus Elise R Schlüssel Programmieren

    Hallo

    Ich hab während ich mein Auto putzte den Schlüssel am Amaturenbrett liegen lassen und dann dort vergessen. Scheinbar hat ihm die Hitze nicht gut getan und er funktionierte dann nicht mehr. Ich hab nun eine neue Batterie hinein gegeben, aber leider ohne Erfolg.

    Wie kann ich den "Schlüssel" nun erneut am Auto anmelden? (Ich mein das Ding für die Zentralverriegelung das leider separat dabei ist)

    LG

    Sascha

    Hallo,

    steht doch in der Betriebsanleitug genau beschrieben. Hast du die Codes für dein Auto?

    Transmitter Re-synchronisation
    If at any time the transmitter does not function, and the battery
    is known to be good, carry out the following re-synchronisation
    procedure:
    - Stand close to the car and hold down both buttons on the
    transmitter until the LED on the fob is extinguished (approx.
    10 seconds).
    - Release both buttons; the fob tell tale should come on constantly.
    - Press the larger button for one second (the fob tell tale will
    flash). Synchronisation is complete.

    oder

    Programming Additional Transmitter Fobs
    Two transmitter fobs are provided with the new car. If one
    transmitter is lost or damaged, a replacement should be obtained
    immediately from your dealer, and programmed to the
    car alarm controller using a functioning transmitter fob and the
    system owner’s unique Personal Identification Number (PIN).
    Up to 4 transmitter fobs can be matched with the alarm system,
    but all fobs must collectively undergo the single programming
    operation:
    1. Press, simultaneously, both buttons on a transmitter fob
    until the fob tell tale stops flashing (approx. 10 seconds).
    On release of the buttons, the fob tell tale will light.
    2. Repeat operation (1) for ALL the transmitter fobs required to
    operate the system.
    3. Turn the ignition on and off 3 times within 7 seconds; the
    security tell tale in the tachometer will light for 3 seconds.
    4. Enter the PIN: Immediately the tell tale goes out, switch ON
    the ignition and count the number of security tell tale flashes
    until equal to the first number of the PIN, then turn the ignition
    OFF, then back ON again.
    5. Repeat operation (4) for the remaining 3 digits of the PIN,
    remembering to turn the ignition OFF and back ON after each
    code number.
    Note: If at any time a mistake is made when entering the
    PIN, turn the ignition OFF for 10 seconds and re-commence
    entering the PIN.
    6. If the PIN is correct, the security tell tale will be lit. Test operation
    of each transmitter fob.